Weidmuller WAVE Analog PRO DC Manual do Utilizador

Operating InstructionsAnalog Signal IsolatorsWAVESERIESWAVEANALOG PRO DC/DCModel Order NumberScrew terminal connectionWAS4 PRO DC/DC 8560740000Tension

4. MountingThe analog signal isolators are mounted on standard TS 35 rails. 5. Electrical connectionWarning! Do not operate inputs for current and vo

6. Dimensions2792.49038111.473.412.5mm

7. Notes on CE markingThe WAS4/WAZ4 PRO DC/DC analog signal isolators are marked CE inaccordance with the EU directives 89/336/EEC "Electromagnet

8. Technical DataInput dataInputsVoltage max. 200 VCurrent max. 100 mAconfigurable from 20 mV to 200 V and adjustable to calibrated values: 60 mV, 100

30

31

1. General instructionsWarning! The analog signal isolators of the WAVEANALOG PRO series mayonly be installed by qualified personnel. Be sure not to c

3. Configuration3.1 EquipmentA screwdriver with a width of 2.5 mm is required to adjust the unit and toconnect the wires to the terminals.3.2 Opening

3.4 WAVETOOL 1.1 setting toolOur software tool WAVETOOL 1.1 is available to simplify equipment setting.Download from the internet at www.weidmueller.d

21

Selected range can be documented on enclosure side. Factory setting: 0 to ±10 V / 0 to ± 10 V, 0 % offset, bandwidth 10 HzSwitchOutput S1 S3Output ran

3.5 Setting examples1..Input –150 mV to +150 mV, output –20 mA to +20 mA2..Input +10 mV to +165 mV, output 0 mA to +20 mAa. Switch on input range 0 to

b. Set input to 155 mV, set output to 20 mA with Span potentiometerc. Activate Zero potentiometer. Set input to 10 mV, set output to 0 mA with Zero po

3.6 Setting tool for all input and output valuesDefinitions: Inmin= smallest input valueInmax= largest input valueOutmin= smallest input valueOutmax=