Weidmuller WI-MOD-E-G Manual do Utilizador Página 21
- Página / 114
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Weidmuller Wireless Ethernet Modem & Device Server WI-MOD-945-E User Manual
Page 21 www.weidmuller.com Rev 2.136
compatible). If there are multiple Access Points it will select the connection with the best signal level. This functionality
permits a client to have mobility whilst maintaining a link with the most suitable AP.
LED Indication
The following table details the status of the indicating LEDs on the front panel under normal operating conditions.
LED Indicator
Condition
Meaning
OK
GREEN
Normal Operation
OK
Flashing RED / GREEN
Module Boot Sequence
Radio RX
GREEN flash
Radio receiving data (Good Signal
Strength)
Radio RX
RED flash
Radio receiving data (Low Signal strength)
TX/LINK
GREEN
Radio Connection Established
TX/LINK
RED Flash
Radio Transmitting
RS-232
GREEN flash
Data sent from RS-232 Serial Port
RS-232
RED flash
Data received to RS-232 Serial Port
LAN
ON
Link Established on Ethernet port
LAN
Flash
Activity on Ethernet port.
RS-485
GREEN flash
Data sent from RS-485 Serial Port
RS-485
RED flash
Data received to RS-485 Serial Port
DIO
GREEN
Digital Input is grounded.
DIO
RED
Digital Output is active
DIO
Off
Digital Output OFF and Input is open circuit.
The Ethernet RJ45 port incorporates two indication LEDs. The LINK LED comes on when there is a connection on the
Ethernet port, and will blink off briefly when activity is detected on the Ethernet Port. The 100MB LED indicates that the
connection is at 100 MBit/Sec. The 100MB LED will be off for 10MB/Sec connection.
Other conditions indicating a fault are described in Chapter Four - DIAGNOSTICS.
3.1 - Selecting a Channel
802.11 (900 MHz) Channels
The WI-MOD-945-E conforms to the IEEE 802.11 Wireless LAN specification and supports various channels depending
on regulations within the country of use.
If operating in the US, Canada, the frequency range is 902 to 928MHz and the available channels are:
9 x non overlapping 1.25MHz channels
9 x partially overlapping 2.5MHz channels
4 x non overlapping 5MHz channels
4 x overlapping 10MHz channels
2 x overlapping 20MHz channels.
If operating in Australia the frequency range is 915-928MHz and the available channels are:
- Version 2.16 1
- Read and Retain for 1
- Future Reference 1
- FCC Notice: 3
- Safety Notices: 3
- UL Notice: 3
- Release Notice: 4
- CONTENTS 6
- CHAPTER 1 - INTRODUCTION 9
- Access Point 10
- CHAPTER 2 - INSTALLATION 13
- Antenna Diversity 14
- Example 14
- Figure 1 - Vulcanizing Tape 15
- Directional antennas 16
- 2.2 - Power Supply 17
- 2.3 - Serial Connections 17
- RS485 Serial Port 18
- Figure 8 - DIO Input 19
- Figure 9 - DIO Output 19
- CHAPTER 3 - OPERATION 20
- 3.1 - Selecting a Channel 21
- Figure 10 - 900MHz Channels 22
- Radio Throughput 23
- Throughput and Repeaters 24
- Default Configuration 25
- Figure 13 – Main Screen 27
- Figure 14 - Dragon 28
- 3.3 - Quick Start 29
- Figure 16 - Network 30
- 3.6 - Security Menu 33
- WEP (64 bit) & (128 bit) 34
- WPA / WPA2 34
- Configuration 35
- 3.7 - Normal Operation 36
- 3.8 - Radio Configuration 36
- Channel Selection 38
- Figure 24 - Advanced Radio 39
- Fixed Noise Floor 40
- RS-232 PPP Server 40
- Modbus TCP to RTU Gateway 43
- 3.11 - Serial Menu 44
- Multicast Pipe Manager 46
- 3.13 - Digital Input/Output 47
- 3.14 - Modbus I/O Transfer 47
- Figure 28 -Modbus TCP 48
- Figure 29 - Modbus 48
- Figure 30 - Modbus Mappings 49
- 3.15 - Roaming 51
- 3.16 - Repeaters (WDS) 53
- WDS Connections: 54
- Figure 36 - WDS Roaming 56
- Figure 38 - WDS Redundancy 57
- Figure 41 - WDS Routed 58
- Figure 44 - Gateway Address 59
- 3.17 - Routing Rules 60
- Figure 46 - Routing Rules 61
- 3.18 - Filtering 62
- 3.22 - VLAN 66
- Operation 67
- VLAN Group 67
- Interface Membership 68
- Examples 68
- Figure 51 - VLAN Example 1 69
- Figure 53 - VLAN Example 2 70
- Figure 55 - VLAN Encryption 72
- Figure 56 - WDS Encryption 72
- Extending a wired network 74
- Figure 58 - Example Config 2 75
- CHAPTER 4 - DIAGNOSTICS 77
- 4.1 - Connectivity 78
- Site Survey 79
- Diagnosing Low Throughput: 80
- Figure 63 - RX Noise Floor 81
- 4.3 - Custom Survey 82
- Figure 66 - Custom Survey 1 83
- Figure 67 - Custom Survey 2 84
- 4.4 - Throughput Test 85
- Figure 72 - Iperf Throughput 86
- 4.5 - Statistics 87
- 4.6 - System Tools 88
- 4.7 - Testing Radio Paths 89
- 4.8 - Remote Configuration 92
- Statistic Registers 94
- 4.10 - Utilities 95
- ”Ipconfig” 96
- ”Route” 96
- Figure 81 - Route 97
- CHAPTER 5 - SPECIFICATIONS 98
- Web based Upgrade 100
- Appendix B - GLOSSARY 101
- Power Conversion 106
- Materials 107
- Installation 107
- Figure 84 108
- Figure 85 108
- Table 1 108
- Figure 86 109
- Figure 87 109
Manuais e produtos relacionados com Redes Weidmuller WI-MOD-E-G
Redes Weidmuller WI-MOD-E-G Manual do Utilizador
(90 páginas)
(90 páginas)
Redes Weidmuller WI-MOD-E-G Manual do Utilizador
(4 páginas)
(4 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.124 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais