Weidmuller WI-MOD-E-G Manual do Utilizador Página 4
- Página / 114
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Page 4 www.weidmuller.com Rev 2.16
Important Notice:
WEIDMULLER products are designed to be used in industrial environments, by experienced industrial engineering
personnel with adequate knowledge of safety design considerations.
WEIDMULLER radio products are used on unprotected license-free radio bands with radio noise and interference. The
products are designed to operate in the presence of noise and interference, however in an extreme case, radio noise and
interference could cause product operation delays or operation failure. Like all industrial electronic products,
WEIDMULLER products can fail in a variety of modes due to misuse, age, or malfunction. We recommend that users and
designers design systems using design techniques intended to prevent personal injury or damage during product
operation, and provide failure tolerant systems to prevent personal injury or damage in the event of product failure.
Designers must warn users of the equipment or systems if adequate protection against failure has not been included in
the system design. Designers must include this Important Notice in operating procedures and system manuals.
These products should not be used in non-industrial applications, or life-support systems, without consulting
WEIDMULLER first.
1. A radio license is not required in some countries, provided the module is installed using the aerial and equipment
configuration described in the WI-MOD-945-E Installation Guide. Check with your local distributor for further
information on regulations.
2. Operation is authorized by the radio frequency regulatory authority in your country on a non-protection basis.
Although all care is taken in the design of these units, there is no responsibility taken for sources of external
interference. Systems should be designed to be tolerant of these operational delays.
3. To avoid the risk of electrocution, the aerial, aerial cable, serial cables and all terminals of the WI-MOD-945-E
module should be electrically protected. To provide maximum surge and lightning protection, the module should
be connected to a suitable earth and the aerial, aerial cable, serial cables and the module should be installed as
recommended in the Installation Guide.
4. To avoid accidents during maintenance or adjustment of remotely controlled equipment, all equipment should be
first disconnected from the WI-MOD-945-E module during these adjustments. Equipment should carry clear
markings to indicate remote or automatic operation. E.g. "This equipment is remotely controlled and may start
without warning. Isolate at the switchboard before attempting adjustments."
5. The WI-MOD-945-E module is not suitable for use in explosive environments without additional protection.
6. The WI-MOD-945-E Operates using the same Radio frequencies and communication protocols as commercially
available off-the shelf equipment. If your system is not adequately secured, third parties may be able to gain
access to your data or gain control of your equipment via the radio link. Before deploying a system make sure you
have considered the security aspects of your installation carefully.
Release Notice:
This is the October 2012 release of the WI-MOD-945-E Ethernet Modem User Manual version 2.16 which applies to
version 2.16 Modem firmware
- Version 2.16 1
- Read and Retain for 1
- Future Reference 1
- FCC Notice: 3
- Safety Notices: 3
- UL Notice: 3
- Release Notice: 4
- CONTENTS 6
- CHAPTER 1 - INTRODUCTION 9
- Access Point 10
- CHAPTER 2 - INSTALLATION 13
- Antenna Diversity 14
- Example 14
- Figure 1 - Vulcanizing Tape 15
- Directional antennas 16
- 2.2 - Power Supply 17
- 2.3 - Serial Connections 17
- RS485 Serial Port 18
- Figure 8 - DIO Input 19
- Figure 9 - DIO Output 19
- CHAPTER 3 - OPERATION 20
- 3.1 - Selecting a Channel 21
- Figure 10 - 900MHz Channels 22
- Radio Throughput 23
- Throughput and Repeaters 24
- Default Configuration 25
- Figure 13 – Main Screen 27
- Figure 14 - Dragon 28
- 3.3 - Quick Start 29
- Figure 16 - Network 30
- 3.6 - Security Menu 33
- WEP (64 bit) & (128 bit) 34
- WPA / WPA2 34
- Configuration 35
- 3.7 - Normal Operation 36
- 3.8 - Radio Configuration 36
- Channel Selection 38
- Figure 24 - Advanced Radio 39
- Fixed Noise Floor 40
- RS-232 PPP Server 40
- Modbus TCP to RTU Gateway 43
- 3.11 - Serial Menu 44
- Multicast Pipe Manager 46
- 3.13 - Digital Input/Output 47
- 3.14 - Modbus I/O Transfer 47
- Figure 28 -Modbus TCP 48
- Figure 29 - Modbus 48
- Figure 30 - Modbus Mappings 49
- 3.15 - Roaming 51
- 3.16 - Repeaters (WDS) 53
- WDS Connections: 54
- Figure 36 - WDS Roaming 56
- Figure 38 - WDS Redundancy 57
- Figure 41 - WDS Routed 58
- Figure 44 - Gateway Address 59
- 3.17 - Routing Rules 60
- Figure 46 - Routing Rules 61
- 3.18 - Filtering 62
- 3.22 - VLAN 66
- Operation 67
- VLAN Group 67
- Interface Membership 68
- Examples 68
- Figure 51 - VLAN Example 1 69
- Figure 53 - VLAN Example 2 70
- Figure 55 - VLAN Encryption 72
- Figure 56 - WDS Encryption 72
- Extending a wired network 74
- Figure 58 - Example Config 2 75
- CHAPTER 4 - DIAGNOSTICS 77
- 4.1 - Connectivity 78
- Site Survey 79
- Diagnosing Low Throughput: 80
- Figure 63 - RX Noise Floor 81
- 4.3 - Custom Survey 82
- Figure 66 - Custom Survey 1 83
- Figure 67 - Custom Survey 2 84
- 4.4 - Throughput Test 85
- Figure 72 - Iperf Throughput 86
- 4.5 - Statistics 87
- 4.6 - System Tools 88
- 4.7 - Testing Radio Paths 89
- 4.8 - Remote Configuration 92
- Statistic Registers 94
- 4.10 - Utilities 95
- ”Ipconfig” 96
- ”Route” 96
- Figure 81 - Route 97
- CHAPTER 5 - SPECIFICATIONS 98
- Web based Upgrade 100
- Appendix B - GLOSSARY 101
- Power Conversion 106
- Materials 107
- Installation 107
- Figure 84 108
- Figure 85 108
- Table 1 108
- Figure 86 109
- Figure 87 109
Manuais e produtos relacionados com Redes Weidmuller WI-MOD-E-G
Redes Weidmuller WI-MOD-E-G Manual do Utilizador
(90 páginas)
(90 páginas)
Redes Weidmuller WI-MOD-E-G Manual do Utilizador
(4 páginas)
(4 páginas)
JVC KD-S891R podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Odbiorniki samochodowe JVC KD-S891R.
Dostarczamy 1 pdf podręczników JVC KD-S891R do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Comentários a estes Manuais