Weidmuller Thermo Signal Conditioners for current & volta Manual do Utilizador descarregar pdf (Página 4)

3.3 Pluggable cross-connections for voltage supply

(s. Fig. 3)

A maximum feed through of 2 A is possible.

If a signal conditioner is accidently rotated through 180°, the

cross-connection cannot be inserted.

3.4 Labelling possibilities

(s. Fig. 4)

WS 10 connector markers can be used to label module.

4 Calibration

Warning!! The power supply must be disconnected, before

changing the signal conditioner settings using the

DIP switches.

Failure to observe will lead to considerable damage!

Note!! The module calibrates itself, when using the DIP

switches on the printed circuit board to set the

temperature range.

1 2 3 4 5 6 7 8 9 ... 13 14

Sem comentários

Weidmuller Thermo Signal Conditioners for current & volta Manual do Utilizador Página 4