Weidmuller DI350 - Display instrument for control panel Manual do Utilizador descarregar pdf (Página 9)

Power Supply Requirements

Check the power supply against the model number before applying

ower to the instrument. DI350 displays must be used with a suitable

mains Power Supply, ratings are as follows:

Voltage Range Nominal Voltage Power Frequency

100–132 V AC 110 V AC 6 VA 47-63 Hz

200–264 V AC 240 V AC 6 VA 47-63 Hz

12–35 V DC* 24 V DC 4.5 W (at 24 V DC) -

*Using a DC power supply that provides this voltage will comply with

the instrument’s UL/CSA listing.

Connections

For effective protection from electromagnetic noise, all signal cables

must be shielded, or located on conductive trays or in conduits.

se 12-28 AWG Cu Wire rated for temperatures above 70 °C Only,

tighten to 4.5 lb-In. Strip wires to 7 mm from the ends. Use a suitable

ferrule for multistranded wires (do not solder).

Terminal Signal

1 +24 V DC

Sensor power supply (Output)

2 0V

3 S

ignal +

Analogue Input

4 Signal −

7 Live (+)

Power Supply

8 Neutral (−)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Weidmuller DI350 - Display instrument for control panel Manual do Utilizador Página 9