Weidmuller ITX+ - Universal signal isolator / amplifier Manual do Utilizador descarregar pdf (Página 20)

• Setup

Getting started

1. Connect the ITXPlus to a spare RS232 serial port on your PC using

the CBX100 interface kit (See diagram above).

2. Switch on the CBX100.

Start the Setup/Calibration software on your PC. [The latest setup/

calibration software is available for free download from our website.]

4. A

pply power to the ITXPlus.

Warning: Take care to avoid touching the internal components when the

front panel is open.

Attenuator switch

For input voltages above 1 V.

1. Push in the lugs marked A & B below.

2. Pull the electronics forward gently to reveal the attenuator switches.

3. S

et the switches to the position required.

4. Recalibrate the inputs (see over).

Attenuator switch location and front panel locating lugs A & B.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 63 64

Sem comentários

Weidmuller ITX+ - Universal signal isolator / amplifier Manual do Utilizador Página 20